Serial ATA SATA to EIDE/IDE Hard Drive (HDD) and Optical Drive CD, DVD Mini Adapter Converter with Power Cable (Retail)

This SATA Serial ATA to IDE Ultra ATA-133 Converter Board is a converter solution for the Parallel Ultra ATA Devices. It has a standard 40 pin ATA port can interface to a parallel Ultra ATA (IDE) devices (such as Hard Disk, DVD-Rom, DVD+-R/W, DVD-RAM, CD-ROM, CD-RW, MO, ….). It accepts SATA commands through the Serial ATA interface from the host, decodes the commands and converts them to parallel ATA commands to the device. Response from the device through the parallel ATA bus are deciphered, processed and converted to SATA protocol and sent to the host.

If your computer does NOT have standard 4-Pin Molex connectors (ex: newer Dell, HP, etc) then you will want to add our SATA Power to 4-Pin Molex Adapter found here

This SATA Serial ATA to IDE Ultra ATA-133 Converter Board supports the Serial ATA Generation 1 transfer rate of 1.5 Gb/s (150 MB/s) on the serial side and is compatible with Ultra ATA-133 on the parallel ATA side.

Attaches this Mini Converter board to back of all types of ATAPI, ATA/133, ATA/100, ATA/66, ATA/33, EIDE and IDE storage devices (such as Hard Disk, DVD-Rom, DVD+-R/W, DVD-RAM, CD-ROM, CD-RW, MO, ….) and make them become new Serial ATA Devices and meet new Serial ATA standard.

This dongle board can support HDD larger than 137GB.

Installation Notes:
1. Make sure to use the included power cable and connect it to the PSU, and Adapter Card
2. Make sure to connect the PSU's 4-Pin Molex directly to HDD
2. Make sure to set the jumper settings on your Hard Drive to Single Device Master

HDMI Cables and Switches
Apogee HDMI 1.3b Cables and Switchers

Core 2 Quad
Intel Quad-Core E8400; Dual- Core E7500

Hard Drive Docking Station
USB 2.0, SATA, Thermaltake, Vantec

Best Sellers